PL-2 Gull Wing Paper Airplane


You really need graphics to make sense of this.

Step 1

    Fold an 8 1/2 x 11 sheet of paper down the middle of the 11" side. Don't panic. Just look at the pictures. On the left I'll show you what you're starting with, and I'll mark (in blue) where you're going to fold. On the right you'll see what you should end up with after each step.

You really need graphics to make sense of this.

Step 2

    Next fold the two upper corners in at a 45-degree angle. Be careful here to line these up, and do not let the flaps cross the middle of the paper. Use the middle fold as a guide.

You really need graphics to make sense of this.

Step 3

    Fold each side, again using the middle as a guide. The two sides must be very even.

You really need graphics to make sense of this.

Step 4

    Fold the tip over, lining the pointy tip up with where the other folds meet in the middle. This provides both the proper center of gravity, and it makes the nose blunt so you won't poke your eye out.

You really need graphics to make sense of this.

Step 5

    Unfold the tip. We'll be folding it back later, but we needed to crease the paper in the right place.

You really need graphics to make sense of this.

Step 6

    Unfold the sides. The plane should look a lot like it did at the end of step 2, but with some folds we need to use as guides.

You really need graphics to make sense of this.

Step 7

    Fold the outer part of each wing in, Line up with the folds from step 3.

You really need graphics to make sense of this.

Step 8

    Fold the outer part of the wing again. What we are doing is making a really strong leading edge and spar for the wing.

You really need graphics to make sense of this.

Step 9

    Fold the wings one more time so we are back to the correct leading edge angle. Note that the leading edges of both wings are now 5 layers thick. This gives us a nice rounded leaning edge and it makes the plane handle crashes better.

You really need graphics to make sense of this.

Step 10

    Fold the tip back using the fold lines we made in step 4. (Notice that the tip doesn't line up with any part of the plane anymore, since we rolled that material up into the leading edges of the wings. That's why I made you mark it with a fold.)

You really need graphics to make sense of this.

Step 11

    Fold down the middle and crease.

You really need graphics to make sense of this.

Step 12

    Do the first fold for the body. The body should be about half the width of the blunt end. (See the drawing)

You really need graphics to make sense of this.

Step 13

    Flip the plane over and fold the other half of the body.

You really need graphics to make sense of this.

Step 14

    Unfold the wings so they lie flat.

You really need graphics to make sense of this.

Step 15

    Now we'll fold the winglets. These winglets are half the width of each wing, so you can just fold them over so they meet the body.

You really need graphics to make sense of this.

Step 16

    Almost done. Unfold the wings and winglets and work them until you get the shape you see on the right. There should be a very pronounced Gull Wing shape in the wings.

You really need graphics to make sense of this.

Step 17

    Flip it over and hold the body a couple inches behind the nose. Now give it a gentle toss. Have fun. (That's an order.)